PPCP 2060
Product Data Sheet
| PHYSICAL PROPERTIES | |||
| ASTM METHOD | PROPERTIES | PROPERTIES (RANGE) | |
| SPECIFIC GRAVITY: W1/ (W1– W2) |
D 792 | 0.925 g/cm3 | 0.910 – 0.940 g/cm3 |
| MELT FLOW: @230°C /2.16kg |
D 1238 | 35 g/10 min | 34 – 37 g/10 min |
| ASH CONTENT: @800°C 15 min |
D 5630 | <2% | 1% – 4% |
| MECHANICAL PROPERTIES | |||
| ASTM METHOD | PROPERTIES | PROPERTIES (RANGE) | |
| TENSILE STRENGTH: @ YIELD |
D 638 | 3,000 psi | 2,500 – 3,400 psi |
| TENSILE ELONGATION: @ BREAK |
D 638 | 10% | 8% -14% |
| FLEXURAL MODULUS: 1% SECANT |
D 790 | 140,000 psi | 120,000 – 160,000 psi |
| IZOD IMPACT STRENGTH: @ BREAK |
D 256 | 2.0 ft-lbs/in | 1.8 – 2.5 ft-lbs/in |
Property Notes
Stated values are based upon reliable testing methods according to ASTM standards. Values are for guideline
purposes only. Actual performance of this material may vary depending upon injection molding conditions or
product design. Material should not be run above degradation temperature as a significant loss of physical
properties may occur.
purposes only. Actual performance of this material may vary depending upon injection molding conditions or
product design. Material should not be run above degradation temperature as a significant loss of physical
properties may occur.
St. Joseph Plastics makes no warranties or specific use recommendation. This data sheet does not guarantee
product performance, license to operate, suitability, conditions for safe handling, or specific fitness of product.
For specific safety recommendations consult the SDS information.
Product standard color is black. Other colors may be available upon request
Suggested Mold Parameters
Melt Temperature:
- Feed Zone: 275°F / 135°C
- Barrel: 375° – 450°F / 191° – 232°C
- Mold: 100° – 150°F / 38o – 66o°C
Injection Pressure: 8,000 – 15,000 psi