SJP 2060 POLYPROPYLENE
Product Data Sheet
Physical Properties
|
ASTM Method |
Properties (Mean) |
Properties (Range) |
|
|
Specific Gravity: W1 / (W1 – W2) |
D792 |
0.923 g / cm3 |
0.918-0.925 g / cm3 |
|
Melt Flow: @230° C /2.16kg |
D1238 |
12 g / 10 min |
11-14 g / 10 min |
|
Ash Content: @800° C 15 min |
D5630 |
2.75 % |
2 % – 4 % |
mechanical Properties
| ASTM Method | Properties (Mean) | Properties (Range) | |
| Tensile Strength: @ Yield | D638 | 2900 psi | 2700 – 3200 psi |
| Elongation: @ Yield | D638 | 7.5 % | 6 % – 9 % |
| Flexural Modulus: 1% Secant | D790 | 145000 psi | 135000 – 150000 psi |
| Izod Impact Strength: @ Break | D256 | 6 ft-lbs / in | 5 – 8 ft-lbs / in |
Property Notes
Values are for guideline purposes only – actual stated values are based upon ASTM testing standards. Performance may vary depending upon injection-molding conditions or product design. Significant loss of physical properties may occur if material is run above degradation temperature.
St. Joseph Plastics makes no warranties or specific use recommendations. This data sheet does not guarantee product performance, license to operate, suitability, conditions for safe handling, or specific fitness of product. For specific safety recommendations consult the SDS information.
Product standard color is black. Other colors available upon request.
Suggested Molding Parameters
|
Melt Temperature: |
Feed Zone: |
350° F / 135° C |
|
|
Barrel: |
375° – 450° F / 191 – 232° C |
||
|
Mold: |
100° – 150° F / 38 – 66° C |
||